1 reply to this topic

[axe360]

I just find it odd that when you go to measure something and you say, put one cube on a high point and drag the other cube down to the lowest point, the up triangle on the tool, stays pointed up?

 

I guess it works ok but seems that if you start at the high side, the triangle would point down, if you went lower?

Seems like one cube would be the starting point and the one you drag would show up or down, depending.

Wouldn't it make more sense that if the cube you're dragging goes below 0 elev. the triangle would point down and vice versa?  No big deal I guess, just curious, maybe that can be fixed?

 

Damn, now I wish I would have taken advantage of helping to test CF.

Edited by axe360, 24 January 2017 - 04:49 PM.

[axe360]

Here is another example of how I would like the measure tool to work.

I am moving from left to right and the triangle should, IMO point down.  Would it be difficult to make that happen?

So, wherever I drop my first cube, the tool should read up or down from there. Not always pointing up.