9 replies to this topic

[M Rose]

Started a new course from an overhead, but all the splines are rendering in the wrong size.

 

I draw the spline, and it comes out like this - the points are in the correct spot, but the shape displayed is the wrong size and in the wrong position. Then while I am adjusting it, the points will snap to the smaller shape and I'll have to manually move them all to where I want them.

 

 

[Armand]

Matthew, is there a setting for the "camera"/perspective that you use in Unity?  It seems to me like perhaps the view isn't orthogonal to where you're drawing the spline.  I'm just guessing though, as my short foray into Unity ended about a week after CF was released!

[Kablammo11]

Looks like your spline is calculated down to the Z=0 axis (slip your camera through the terrain to check if the spline clings to the horizontal plane).

 

Seems CF does not "get" that your base terrain is the intended target for its splines. I've had this a few times many years ago and do not remember what caused it back then... something about folder hierarchies on your hard drive... Perhaps deleting CF from your project and importing it again might help, but I'm not sure. PM to Mike and he'll sort you out in a few minutes. If you have invested any personal efforts into these splines: No need to delete them, they eventually will snap into place once the underlying issue is adressed.

[M Rose]

Re-importing Course Forge didn't fix it, so I wonder if it is a Unity issue.

 

Trying to think if I did anything different when setting this up.

[M Rose]

I inserted a couple of shapes and they sit where they are supposed to, but then I discovered another issue - there's no brushes showing up.

 

This entire thing is strange.

[M Rose]

I placed a tee and a pin on the first hole, and both of them were about 10 feet above the plot. So there's obviously something wrong with the elevation.

[NoPutt]

And meshes at the usual .15 ?

[M Rose]

Yeah, I've got those settings.

 

Now Course Forge isn't even working, so I don't know what the hell is happening. I may just start the whole project over. At this point I'm not really losing any work.

[nstone73]

Build settings under File? (PC, Mac etc)

[M Rose]

I just moved it all into a new project and everything is fine. Not sure what the deal was, but it's all good now.