As the first step in learning how to use CF I am creating a single hole. In this case it is a 450 yard par 4. I have drawn the green but then went on to draw the fairway. Because of the yardage of the hole I have had to move my camera quite high so that I can get the entire hole in the 3D View Window. This however makes the line for drawing the fairway very small. If move the camera closer to the ground it is easier to draw but then I'm not sure how I can scroll the view as I draw the line. Hope I am making sense here. Thanks.
How to Scroll While Drawing Shapes
Started by
slouis
, Oct 17 2016 03:38 AM
Best Answer Armand , 17 October 2016 - 05:42 AM
Use the point-to-point method of drawing the splines. Then you can zoom, re-position, pan, etc. your view before you make the next click on your point-to-point spline.
Go to the full post
1 reply to this topic
#1
slouis
-
- Members
-
- 746 posts
Advanced Member
- LocationCalgary
Posted 17 October 2016 - 03:38 AM
RTSM - Pro
#2
Armand
-
- Members
-
- 1,387 posts
Advanced Member
- LocationCalgary
Posted 17 October 2016 - 05:42 AM Best Answer
Use the point-to-point method of drawing the splines. Then you can zoom, re-position, pan, etc. your view before you make the next click on your point-to-point spline.
- ed dawson likes this
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
