8 replies to this topic

[wpm87unc]

I have two instances I can't figure out after watching the video again and reading the forum. When I hit into the river, i get a rehit option, and a drop over 1000 yds away, but no drop 2 club lengths from entry point.  Same issue with pond that is circled by two Par 3's. Any suggestions would be appreciated.

 

 Screenshot (1).gif   212.54KB   0 downloads

 

 Screenshot (2).gif   192.46KB   0 downloads

 

I also have the same issues with other ponds, I have put the yellow splits in but still no luck.

[Sliceapottomus]

video prob is the way to go. Mark with red stakes then any forced carries should have the yellow stakes. just follow mikes tutorial to the tee and you should be ok...

[wpm87unc]

I have tried several times, in fact I have moved the small yellow sections all over without any luck.  It's like it is reading the end result, in the water, but not realizing it crossed a red line to get there.

Looking at these images, where would you recommend I try?

[NoPutt]

That first pic looks like it has a red spline down the

side of the river. Laterals go on side, Regular hazard

would be in front of shot. 

Hard to tell with the pond pic but usually ponds

just need to be all Red unless they are on the side of a par 3.

Make sure you are also adjusting the direction between hazard points,

the arrows should face each other.

    

Just a quick sample

 

[wpm87unc]

when I put the yellow on the ends like this example, if the ball lands in the water, my drop options are as if i went in on the ends, only do over or drop way back.  Is there a setting or something I have to check?

[johnmeyer]

Have you got more than 1 Out of Bounds Spline?

[wpm87unc]

i do, I have the one around the entire course and two on the course, is this the problem?

[NoPutt]

Could be one problem. Only 1 OB spline is allowed, usually

around the whole course, but it can snake into the interior.

[wpm87unc]

Seems to have fixed the hazard question.  But now, everytime I land in a fairwary, I get a splash.  The loaded library is read only, but it does show fairway when I select the spline.  Any thoughts?