Jump to content


Photo

Bulkheads in Blender


Best Answer wpm87unc , 09 January 2019 - 04:40 AM

rotated before applying modifiers.  Thanks Larry for your help

Go to the full post


  • Please log in to reply
4 replies to this topic

#1 wpm87unc

wpm87unc

    Advanced Member

  • Members
  • PipPipPip
  • 52 posts

Posted 09 January 2019 - 02:02 AM

I have the wall and did one of my bulkheads with no problem.  then on the second, when I went to apply the second modifier to curve, the wall formed but upside down, so my plank was on the bottom.  Any ideas what might have happened.  Actually tried twice with same result.



#2 DPRoberts

DPRoberts

    Advanced Member

  • Members
  • PipPipPip
  • 1,610 posts

Posted 09 January 2019 - 02:37 AM

Did it look correct and then change after "applying" the modifier?

Did you try changing the deformation axis to the negative value of whatever axis was working?

You could also probably select your wall pieces in edit mode and rotate them 180 degrees.

I haven't watched that video in a while but I rarely APPLY my modifiers anymore in the stack. I realized you can select the entire object without the modifiers applied and it'll export as it appears basically with the modifier applied. Hope that makes sense.

#3 DPRoberts

DPRoberts

    Advanced Member

  • Members
  • PipPipPip
  • 1,610 posts

Posted 09 January 2019 - 02:44 AM

There is also probably a need for a revised video "Super Easy Rapid Bulkheads Without Blender"

This is using the waterpotty method and can be done using CF splines. For a little variety, you can then just add posts every few meters.

Checkout Highfade's par 3 challenge course. Abel's...I think it's hole 4/5

#4 wpm87unc

wpm87unc

    Advanced Member

  • Members
  • PipPipPip
  • 52 posts

Posted 09 January 2019 - 02:49 AM

I applied the array, then the curve.  the curve is where it flipped



#5 wpm87unc

wpm87unc

    Advanced Member

  • Members
  • PipPipPip
  • 52 posts

Posted 09 January 2019 - 04:40 AM   Best Answer

rotated before applying modifiers.  Thanks Larry for your help






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users